ER Compass
live + archived ER waits

Providence Health Care - Mount Saint Joseph Hospital

Vancouver, BC · Hospital website ↗
☎ (604) 874-1141
no wait posted right now
High confidence, official hospital feed, updated 6 min ago
Posted by the hospital · 2026-09-11T07:38:39.627Z

This ER reports its live wait intermittently, and isn't posting one right now. Typically about 23 min at this hour, from its own recorded history (see the pattern below).

Nearest ER reporting live: Vancouver General Hospital, 8h 1m (2 km away) →

typical at this hour
23 min
this ER's own history for this hour
calmest hour
11pm
typically 22 min
Directions ↗
Get a ride: Uber Lyft
Compare nearby ERs on the map →

Call 911 for an ambulance if you need one.

When this ER is busiest

Based on our archive, this emergency room is typically busiest around 10am and on Mondays, and quietest around 11pm and on Saturdays.

1h2hcalmest
12a6a12p6p11p

Over the last month its posted wait has typically been about 1h 18m, ranging roughly 23 min to 2h 20m.

For a non-urgent visit, a calmer hour usually means a shorter wait; in an emergency, go to the nearest ER no matter the time.

How reliable is this number?

Over the last 57.9 h, this ER's posted wait refreshes about every 18 min, has ranged 21 min–3h 20m.

Measured from our own archive of what this hospital posted. See how we check accuracy

Getting there

Logistics from OpenStreetMap, to help plan your arrival, not medical guidance. In an emergency, go straight to the nearest entrance and ask staff.

Time to be seen (CIHI)

Across British Columbia, 9 in 10 patients were seen by a physician within ~5h.

For comparison, the wait this ER has posted runs a median of ~1h 18m over the stretch we've tracked it, the typical live estimate, where the CIHI figure above is the long-wait tail (the slowest 1 in 10).

Province-wide, no hospital-level figure is published for this site. CIHI, fiscal 2024–2025. Source ↗

If you're admitted (CIHI)

Across British Columbia, 9 in 10 admitted patients spent under ~64h 42m in the ED waiting for an inpatient bed.

Most ER visits end in discharge and are far shorter, this is the admitted-patient (boarding) figure. Province-wide, no hospital-level figure for this site. CIHI, fiscal 2024–2025. Source ↗

Typical in British Columbia (CIHI)

half of discharged ED visits finish within ~2.9–4.3 h; 9 in 10 within ~8.9 h.

Province-wide total time in the ED (arrival to leaving), Apr–Sep 2025, a ballpark where there's no live wait, not this hospital's posted number.

Nearby emergency rooms

Frequently asked questions

How long is the ER wait at Providence Health Care - Mount Saint Joseph Hospital right now?
Providence Health Care - Mount Saint Joseph Hospital doesn't publish a live wait time we can read right now. A blank means we have no live number, not that the ER is closed. Check the current status and phone number above, or call ahead.
What does the wait time actually measure?
Usually the estimated time to be seen by a physician, but Canada has no common definition. Quebec publishes stretcher occupancy, New Brunswick length of stay, and others an estimate of the wait to be seen, so we keep each province in its own units and never blend them into one misleading number.
How accurate are these ER wait times?
They are the live estimates each hospital publishes, refreshed about every 10 minutes; we stamp every reading with the moment the hospital said it was current and flag a feed that goes stale. They are estimates, not guarantees, an emergency room always sees the sickest patients first, so your own wait can differ. We also backtest our forecasts against what hospitals post next; see the accuracy page.
Should I go to the ER, or somewhere else?
For anything life-threatening, call 911 or go to the nearest emergency room now, never wait for a shorter posted time. For a non-urgent problem, calling 811 (free 24/7 health advice), a walk-in clinic, or a pharmacist is often faster. When in doubt, get checked.

Add this wait time to your site

Free to embed, a live wait-time badge for this ER that updates automatically. Copy the code: